Box with different height in each corner
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
the angle of arc cuts
the gap between grooves (fraction of the edge length)
alternate the direction of grooves
invert the groove directions
minimum space left and right without grooves (fraction of the edge length)
the style of grooves
the angle of triangular cuts
the width of each groove (fraction of the edge length)
edge type for bottom edge
inner width in mm (unless outside selected)
inner depth in mm (unless outside selected)
treat sizes as outside measurements 🛈
height of the front left corner in mm
height of the front right corner in mm
height of the right back corner in mm
height of the left back corner in mm
add a lid (works best with high corners opposing each other)
additional height of the lid
which edges are flat (e) or grooved (z,Z), counter-clockwise from the front
thickness of the material (in mm) 🛈
format of resulting file 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
print surrounding boxes for some structures 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
style for inner corners 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
Generate Save to URL
