Макеты для лазерной резки

Boxes.py

TwoPiece

A two piece box where top slips over the bottom half to form the enclosure.

Settings for Finger Joints

angle
style		style of the fingers
surroundingspaces		space at the start and end in multiple of normal spaces
bottom_lip		height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
edge_width		space below holes of FingerHoleEdge (multiples of thickness)
extra_length		extra material to grind away burn marks (multiples of thickness)
finger		width of the fingers (multiples of thickness)
play		extra space to allow finger move in and out (multiples of thickness)
space		space between fingers (multiples of thickness)
width		width of finger holes (multiples of thickness)

TwoPiece Settings

x		inner width in mm (unless outside selected)
y		inner depth in mm (unless outside selected)
h		inner height in mm (unless outside selected)
hi		inner height of inner walls in mm (unless outside selected)(leave to zero for same as outer walls)
outside		treat sizes as outside measurements 🛈
play		play between the two parts as multiple of the wall thickness

Default Settings

thickness		thickness of the material (in mm) 🛈
format		format of resulting file 🛈
tabs		width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
debug		print surrounding boxes for some structures 🛈
labels		label the parts (where available)
reference		print reference rectangle with given length (in mm)(zero to disable) 🛈
inner_corners		style for inner corners 🛈
burn		burn correction (in mm)(bigger values for tighter fit) 🛈

Set hi larger than h to leave gap between the inner and outer shell. This can be used to make opening the box easier. Set hi smaller to only have a small inner ridge that will allow the content to be more visible after opening.

Bottom view