Stackable rackable racks for SBC Pi-Style Computers
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
inside angle of the feet
height of strips to be glued to the inside of bottom edges (multiples of thickness)
height of the feet (multiples of thickness)
distance from finger holes to bottom edge (multiples of thickness)
width of the feet (multiples of thickness)
inner width in mm
inner depth in mm
how many slots for sbcs
clearance for the board in the box (x) in mm
clearance for the board in the box (y) in mm
SBC Clearance in mm
hole distance from edge in mm
width of x hole area
width of y hole area
hole diameters
height of the net/usb hole mm
width of the net/usb hole in mm
draw some holes to put a 1/4" dowel through at the base and top
adds an additional vertical segment to hold the switch in place, works best w/ --stable
thickness of the material (in mm) 🛈
format of resulting file 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
print surrounding boxes for some structures 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
style for inner corners 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
Generate Save to URL
