Boxes - RoyalGame— CNChub.ru

Settings for Finger Joints

angle
style		style of the fingers
surroundingspaces		space at the start and end in multiple of normal spaces
bottom_lip		height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
edge_width		space below holes of FingerHoleEdge (multiples of thickness)
extra_length		extra material to grind away burn marks (multiples of thickness)
finger		width of the fingers (multiples of thickness)
play		extra space to allow finger move in and out (multiples of thickness)
space		space between fingers (multiples of thickness)
width		width of finger holes (multiples of thickness)

RoyalGame Settings

inner width in mm

Default Settings

thickness		thickness of the material (in mm) 🛈
format		format of resulting file 🛈
tabs		width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
debug		print surrounding boxes for some structures 🛈
labels		label the parts (where available)
reference		print reference rectangle with given length (in mm)(zero to disable) 🛈
inner_corners		style for inner corners 🛈
burn		burn correction (in mm)(bigger values for tighter fit) 🛈

Most of the blue lines need to be engraved by cutting with high speed and low power. But there are three blue holes that actually need to be cut: The grip hole in the lid and two tiny rectangles on the top and bottom for the lid to grip into.

Lid Details

All pieces

Boxes.py

RoyalGame

Settings for Finger Joints

RoyalGame Settings

Default Settings