Box with vertical edges rounded
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
how much should fingers widen (-80 to 80)
how far the dove tails stick out of/into the edge (multiples of thickness)
radius used on all four corners (multiples of thickness)
from one middle of a dove tail to another (multiples of thickness)
Hint of how much the flex part should be shortened
width of the gaps in the cuts (multiples of thickness)
width of the pattern perpendicular to the cuts (multiples of thickness)
width of the pattern in direction of the cuts (multiples of thickness)
sections bottom to top in mm 🛈
inner width in mm (unless outside selected)
inner depth in mm (unless outside selected)
treat sizes as outside measurements 🛈
Radius of the corners in mm
number of pieces for outer wall
edge type for top and bottom edges
style of the top and lid
thickness of the material (in mm) 🛈
format of resulting file 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
print surrounding boxes for some structures 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
style for inner corners 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
Generate Save to URL
Default: edge_style = f Finger Joint:
Alternative: edge_style = h Edge (parallel Finger Joint Holes):
With lid:
