Макеты для лазерной резки

Boxes.py

RollHolder

Holder for kitchen rolls or other rolls

Settings for Finger Joints

angle
style		style of the fingers
surroundingspaces		space at the start and end in multiple of normal spaces
bottom_lip		height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
edge_width		space below holes of FingerHoleEdge (multiples of thickness)
extra_length		extra material to grind away burn marks (multiples of thickness)
finger		width of the fingers (multiples of thickness)
play		extra space to allow finger move in and out (multiples of thickness)
space		space between fingers (multiples of thickness)
width		width of finger holes (multiples of thickness)

RollHolder Settings

width		length of the axle in mm
diameter		maximum diameter of the roll in mm (choose generously)
height		height of mounting plate in mm
axle		diameter of the axle in mm including play
screw_holes		diameter of mounting holes in mm
one_piece		have a continuous back plate instead of two separate holders

Default Settings

thickness		thickness of the material (in mm) 🛈
format		format of resulting file 🛈
tabs		width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
debug		print surrounding boxes for some structures 🛈
labels		label the parts (where available)
reference		print reference rectangle with given length (in mm)(zero to disable) 🛈
inner_corners		style for inner corners 🛈
burn		burn correction (in mm)(bigger values for tighter fit) 🛈

Needs a dowel or pipe as axle.