Макеты для лазерной резки

Boxes.py

RegularBox

Box with regular polygon as base

Settings for Finger Joints

angle
style		style of the fingers
surroundingspaces		space at the start and end in multiple of normal spaces
bottom_lip		height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
edge_width		space below holes of FingerHoleEdge (multiples of thickness)
extra_length		extra material to grind away burn marks (multiples of thickness)
finger		width of the fingers (multiples of thickness)
play		extra space to allow finger move in and out (multiples of thickness)
space		space between fingers (multiples of thickness)
width		width of finger holes (multiples of thickness)

RegularBox Settings

h		inner height in mm (unless outside selected)
outside		treat sizes as outside measurements 🛈
radius		inner radius if the box (at the corners)
n		number of sides
top		style of the top and lid
alignment_pins		diameter of the alignment pins for bayonet lid

Default Settings

thickness		thickness of the material (in mm) 🛈
format		format of resulting file 🛈
tabs		width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
debug		print surrounding boxes for some structures 🛈
labels		label the parts (where available)
reference		print reference rectangle with given length (in mm)(zero to disable) 🛈
inner_corners		style for inner corners 🛈
burn		burn correction (in mm)(bigger values for tighter fit) 🛈

For short side walls that don't fit a connecting finger reduce surroundingspaces and finger in the Finger Joint Settings.

The lids needs to be glued. For the bayonet lid all outside rings attach to the bottom, all inside rings to the top.