Настольный держатель для смартфона
Вид шипа
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
Расстояние под отверстиями под ШИП. Позволяет поднять дно.
Удлиненный ШИП, для шлифовки. Чтобы избавиться от коричневых торцов [кратное толщине материала]
Ширина шипа [кратное толщине материала]
Зазор отверстия под шип [кратно толщине]
Пробел между шипами [кратное толщине материала]
Толщина паза [кратное толщине материала]
Height of the phone.
Width of the phone.
Depth of the phone. Used by the bottom support holding the phone, and the side tabs depth as well. Should be at least your material thickness for assembly reasons.
angle at which the phone stands, in degrees. 0° is vertical.
Height of the support below the phone
Length of the tabs holding the phone
Spacing between the two bottom support. Choose a value big enough for the charging cable, without getting in the way of other ports.
Толщина материала в мм
Формат файла для скачивания
Ширина перемычек в мм, чтобы деталь не выпадала при резке [поддерживается не везде]
Печатать обрамление для некоторых структур
Подписать детали [если доступно]
Вывод эталонного прямоугольника с заданной длиной [в мм] [0 для отключения]
Стиль для внутренних углов
Коррекция реза лазером в мм [большие значения для более плотной посадки в пазы]
Создать Сгенерировать URL с настройками
This phone stand holds your phone between two tabs, with access to its bottom, in order to connect a charger, headphones, and also not to obstruct the mic. Default values are currently based on Galaxy S7.