Макеты для лазерной резки

Boxes.py

FilamentSpool

A two part spool for 3D printing filament

Settings for Finger Joints

angle
style		style of the fingers
surroundingspaces		space at the start and end in multiple of normal spaces
bottom_lip		height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
edge_width		space below holes of FingerHoleEdge (multiples of thickness)
extra_length		extra material to grind away burn marks (multiples of thickness)
finger		width of the fingers (multiples of thickness)
play		extra space to allow finger move in and out (multiples of thickness)
space		space between fingers (multiples of thickness)
width		width of finger holes (multiples of thickness)

FilamentSpool Settings

h		inner height in mm
outer_diameter		diameter of the flanges
inner_diameter		diameter of the center part
axle_diameter		diameter of the axle hole
sides		number of pieces for the center part
alignment_pins		diameter of the alignment pins

Default Settings

thickness		thickness of the material (in mm) 🛈
format		format of resulting file 🛈
tabs		width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
debug		print surrounding boxes for some structures 🛈
labels		label the parts (where available)
reference		print reference rectangle with given length (in mm)(zero to disable) 🛈
inner_corners		style for inner corners 🛈
burn		burn correction (in mm)(bigger values for tighter fit) 🛈

Use small nails to properly align the pieces of the bayonet latch. Glue the parts of the bayonet latch before assembling the "axle". The inner parts go at the side and the outer parts at the inside of the axle. opened spool