Boxes.py


DrillStand

Box for drills with each compartment of a different height

Settings for Stackable Edges

Settings for Finger Joints

DrillStand Settings

sx

sections left to right in mm 🛈

sy

sections back to front in mm 🛈

sh

sections bottom to top in mm 🛈

extra_height

height difference left to right

Default Settings

thickness

thickness of the material (in mm) 🛈

format

format of resulting file 🛈

tabs

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

debug

print surrounding boxes for some structures 🛈

labels

label the parts (where available)

reference

print reference rectangle with given length (in mm)(zero to disable) 🛈

inner_corners

style for inner corners 🛈

burn

burn correction (in mm)(bigger values for tighter fit) 🛈



Note: sh gives the hight of the rows front to back. It though should have the same number of entries as sy. These heights are the one on the left side and increase throughout the row. To have each compartment a bit higher than the previous one the steps in sh should be a bit bigger than extra_height.

Assembly:

Parts

Start with putting the slots of the inner walls together. Be especially careful with adding the bottom. It is always asymmetrical and flush with the right/lower side while being a little short on the left/higher side to not protrude into the side wall.

Assembly inner walls Assembly bottom
Then add the front and the back wall. Add the very left and right walls last.
Assembly front and back Assembly side walls
There is no image yet. Please donate an image of your project on GitHub!