Boxes - DividerTray— CNChub.ru

Settings for Finger Joints

angle
style		style of the fingers
surroundingspaces		space at the start and end in multiple of normal spaces
bottom_lip		height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
edge_width		space below holes of FingerHoleEdge (multiples of thickness)
extra_length		extra material to grind away burn marks (multiples of thickness)
finger		width of the fingers (multiples of thickness)
play		extra space to allow finger move in and out (multiples of thickness)
space		space between fingers (multiples of thickness)
width		width of finger holes (multiples of thickness)

Settings for HandleEdge

height		height above the wall in mm
hole_height		height of hole(s) in percentage of maximum hole height (handle height - 2 * material thickness)
hole_width		width of hole(s) in percentage of maximum hole width (width of edge - (n+1) * material thickness)
on_sides		added to side panels if checked, to front and back otherwise (only used with top_edge parameter)
radius		radius of corners in mm
outset		extend the handle along the length of the edge (multiples of thickness)

Settings for Divider Slots

angle		angle at which slots are generated, in degrees. 0° is vertical.
depth		depth of the slot in mm
extra_slack		extra slack (in addition to thickness and kerf) to help insert dividers in mm
radius		radius of the slot entrance in mm

Settings for Notches on the Dividers

depth
lower_radius
upper_radius

Settings for Dividers

bottom_margin		margin between box's bottom and divider's in mm
play		play to avoid them clamping onto the walls (in multiples of thickness)

DividerTray Settings

sx		sections left to right in mm 🛈
sy		sections back to front in mm 🛈
h		inner height in mm (unless outside selected)
outside		treat sizes as outside measurements 🛈
notches_in_wall		generate the same notches on the walls that are on the dividers
left_wall		generate wall on the left side
right_wall		generate wall on the right side
bottom		generate wall on the bottom
handle		add handle to the bottom

Default Settings

thickness		thickness of the material (in mm) 🛈
format		format of resulting file 🛈
tabs		width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
debug		print surrounding boxes for some structures 🛈
labels		label the parts (where available)
reference		print reference rectangle with given length (in mm)(zero to disable) 🛈
inner_corners		style for inner corners 🛈
burn		burn correction (in mm)(bigger values for tighter fit) 🛈

Adding '0:' at the start of the sy parameter adds a slot at the very back. Adding ':0' at the end of sy adds a slot meeting the bottom at the very front. This is especially useful if slot angle is set above zero.

There are 4 different sets of dividers rendered:

With asymmetric tabs so the tabs fit on top of each other
With tabs of half wall thickness that can go side by side
With tabs of a full wall thickness
One single divider spanning across all columns

You will likely need to cut each of the dividers you want multiple times.

Boxes.py

DividerTray