Макеты для лазерной резки

Boxes.py

CardHolder

Shelf for holding (multiple) piles of playing cards / notes

Settings for Grooved Edge

arc_angle		the angle of arc cuts
gap		the gap between grooves (fraction of the edge length)
interleave		alternate the direction of grooves
inverse		invert the groove directions
margin		minimum space left and right without grooves (fraction of the edge length)
style		the style of grooves
tri_angle		the angle of triangular cuts
width		the width of each groove (fraction of the edge length)

Settings for Finger Joints

angle
style		style of the fingers
surroundingspaces		space at the start and end in multiple of normal spaces
bottom_lip		height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
edge_width		space below holes of FingerHoleEdge (multiples of thickness)
extra_length		extra material to grind away burn marks (multiples of thickness)
finger		width of the fingers (multiples of thickness)
play		extra space to allow finger move in and out (multiples of thickness)
space		space between fingers (multiples of thickness)
width		width of finger holes (multiples of thickness)

CardHolder Settings

sx		sections left to right in mm 🛈
y		inner depth in mm (unless outside selected)
h		inner height in mm (unless outside selected)
outside		treat sizes as outside measurements 🛈
angle		backward angle of floor
stackable		make holders stackable

Default Settings

thickness		thickness of the material (in mm) 🛈
format		format of resulting file 🛈
tabs		width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
debug		print surrounding boxes for some structures 🛈
labels		label the parts (where available)
reference		print reference rectangle with given length (in mm)(zero to disable) 🛈
inner_corners		style for inner corners 🛈
burn		burn correction (in mm)(bigger values for tighter fit) 🛈